AquaVape³ Water Filter with 10 to 14 mm “long” Adapter made of glass for Davinci IQ / MIQRO
This water filter is made of robust borosilicate glass and provides for a more pleasant inhalation when using with different vaporizers.
PLEASE NOTE: Vaporizers are mostly electric appliances. For this reason they must not come into touch with water. Please don’t fill in too much water or tilt the water filter too much so that no water leaks! Before putting it on the vaporizer please check if the cut is dry and no water can enter the vaporizer or heating chamber!
Please pre-heat the heating chamber before attaching the mouthpiece (stainless steel expands) ensuring the adapter fits. Should the adapter still not fit despite pre-heating then please put in the freezer for a couple of minutes (glass contracts when exposed to cold).
- Two-piece with cap: easy filling and easier cleaning
- High quality and thick borosilicate glass
- Smaller, slimmer and better to handle
- Optimal amount of water is held and the perk slots are completely covered
- Nevertheless, no high splash of water … the mouth stays dry
- Accurate 14mm cut (no wobbling)
- Height: 125 mm
- Diameter: 30 mm
- water filtration
- a lot of percolators
- Borosilicate glass / glassware
- 14er inside cut (14.5 mm)
- 1x AquaVape³ Water Filter made out of lab glass 14″ cut
- 1x Water filter adapter “long” made out of lab glass with 10 to 14″ cut
Specification: AquaVape³ Water Filter with 10 to 14 mm “long” Adapter made of glass for Davinci IQ / MIQRO